CY8C24894 USB DRIVER

At first it appeared to be strange and turned the wrong away, but this is the only way to fit it. The advantage are the debug capabilities as breakpoints, variable inspection and even a trace buffer. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. As written in the guide, the programmer gets power through the USB connection. My USB port was neither able to drive both MiniProg and simultanously the avnet pcb, neither it was able to power it through MiniProg, like described in the manual. I have only ISSP connector available:

Uploader: Kalmaran
Date Added: 1 September 2009
File Size: 67.88 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 70512
Price: Free* [*Free Regsitration Required]

As written in the guide, the programmer gets power through the USB connection. I found the document for the Spartan 3A board.

3PCS CY8C24894-24LTXI CY8C24894-24L QFN56

For those who have the same problem of updating the PCB: Thanks alot, all help cy824894 be awesome! What I physically observe: Functionality should be like when you send packet from PC, it should go to both spare buses. My USB port was neither able to drive both MiniProg and cy8c248894 the avnet pcb, neither it was able to power it through MiniProg, like described in the manual.

See Also  WU5205 DRIVER

Message 2 of 10 10, Views.

Then you can start your project on that kit and clone it later into your target device. Now this is the point where I am stuck! The product detailed below complies with the specifications published by RS Components.

So I aquired all of the documentation on how to return the board to its original state, and I have been trying to program this PSoC IC for the past hour. Hello all, I accidentally deleted the firmware that comes pre installed with the board for the PSoC chip.

I tried lowering communication speed and used drive done pin high in the Xilinx Setup and the it worked. Does the power jumper on the top right of the board need to be moved to the program position in order to program the PSoC device? Message 10 of 10 8, Views.

Can not reprogram PSOC with MiniProg / Please Help – Technical Community

Which device did you select while using PSoC Prog. Thank you for the replies guys! After reading the suggestions it is working Thanks. Bing [Bot]Google [Bot] and 0 guests.

The Manufacturers disclaim all warranties including implied warranties of merchantability or fitness for a particular purpose and are not liable for any damages arising from your use of cy8c2484 your inability to use the Information downloaded from this website. Message 4 of 10 10, Views. Then when going through the docu, I found the hint to the new firmware of the Spartan located in the The jumper setting is as described in uab schematics sheet: Board index All times are UTC.

See Also  DCR-PC109E DRIVER

I pointed Miniprog to this file via load and it seemed to have programmed.

Can not reprogram PSOC with MiniProg / Please Help!

Message 6 of 10 10, Views. Similarly, setting the mode to Reset if there is no external power, also results in this error. I somehow have the same issue here. I played with the power settings too without a result.

CY8CLTXAT Price & Stock | DigiPart

At first it appeared to be strange and turned the wrong away, but this is the only way to fit it. Then is is possible to load the newer 1. Thank you very much Best Michal. Minimum Operating Supply Voltage. Also, I updated the firmware of the programmer from 1. Message 3 of 10 10, Views. The issue was the USB power.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top